Price Clear







Showing DECAL SETTER/SOFTER product(s)

Showing 1 - 4 of 4 products

img
SAVERM13.80

Mr Hobby Mr. Mark Softer

This is a softening agent for slide marks. It has the effect of closely adhering slidemarks to curved surfaces.

  • First, apply a quick drop to the area where the decal will go using the brush attached to the cap.
  • Apply decal over it.
  • Apply gentle pressure to the decal with a soft cloth, removing any excessive liquid and sticking the decal down fast.
  • The decal will stick perfectly, even on uneven or curved surfaces.
  • If air gets in between the decal and the model surface, after drying delicately prick the decal with a needle and insert Mr.MARK SOFTER through the resulting hole. The air will escape, and the decal will stick down firmly.
  • Capacity: 40ML

RM15.10
img
SAVERM11.00

Mr Hobby Mr. Mark Setter 40ML

  • Apply the mark setter to the position where decal is to be stuck.
  • Stick a slide mark
  • Spread it evenly and remove water with a swab, etc.
  • Apply the mark softer on it, remove water again.

In the past, Mr. MARK SOFTER was used simply to soften decals. 

However, now, using Mr. MARK SOFTER together with Mr. MARK SETTER (which gives decals greater adhesiveness) makes it much easier to affix decals to plastic models. 

First, the area to which the decal will be affixed is painted and the decal is applied. 

After air bubbles are removed by pressing on the decal with a cotton swab, a coating of Mr. MARK SOFTER is applied and allowed to dry. 

Because the decal now has greater adhesiveness, adhesive silvering (the floating and shiny quality of the clear parts of decals) can be firmly affixed to uneven surfaces. 

It is perfect even for poorly made decals from Eastern European models. 

Decals have better adhesiveness if the painted surface is prepared to have a glossy appearance, and they gain an appearance that suggests they were drawn by hand.

RM17.90
img
SAVERM7.40

Tamiya Mark Fit 40ML

【 Perfect Decal Application 】   


Mark Fit enables perfect decal applications. It softens decals so they can easily fit to uneven, rounded, and matt finish surfaces of plastic models while increasing adhesion. The bottle's cap comes with a convenient brush. 1 bottle contains 40ml.

-  ‰ªHow to use -  ‰«
1. Apply Mark Fit to the model where decal is applied.
2. Place decal on the model.
3. Position decal by an wetting finger.
4. Press decal down gently with a soft cloth or cotton swab until excess water is gone.
5. Apply Mark Fit over the decal, then press down gently with a soft cloth or cotton swab.
6. Allow the decal to completely dry.

RM18.50
img
SAVERM7.00

Tamiya Mark Fit Strong 40ML

【 Perfect Decal Application 】   


Mark Fit enables perfect decal applications. It softens decals so they can easily fit to uneven, rounded, and matt finish surfaces of plastic models while increasing adhesion. The bottle's cap comes with a convenient brush. 1 bottle contains 40ml.

≪How to use≫
1. Apply Mark Fit to the model where decal is applied.
2. Place decal on the model.
3. Position decal by an wetting finger.
4. Press decal down gently with a soft cloth or cotton swab until excess water is gone.
5. Apply Mark Fit over the decal, then press down gently with a soft cloth or cotton swab.
6. Allow the decal to completely dry.

RM18.00

Showing 1 - 4 of 4 products